12
Utility
12-28 C300
Utility Chapter 12
2
Reminder
The “Output Tray Setting” parameter is available only if optional Output
Tray is installed.
Date/Time Setting
Daylight Saving Time Setting
Weekly Timer Setting
Offset by Each Job Set-
ting
Select whether or not printed copies are
fed out shifted when “Offset” is selected
while a finisher is installed.
ON:
Pages are fed out shifted.
OFF:
Pages are fed out without being shifted.
ON
Parameter Description Default Setting
Description Default Setting
Specify the current date and time. In addition, the time zone can be
set between -12:00 and 13:00 (in 30-minute increments).
Time Zone: +00:00
Description Default Setting
Select whether or not the machine’s internal clock observes daylight
saving time.
If “ON” is selected, a setting appears so that the length of time for
adjusting the current time can be set. The daylight saving time can
be set between 1 and 150 minutes in 1-minute increments.
OFF
Parameter Description Default Setting
Weekly Timer ON/OFF
Setting
Select whether or not the weekly timer
function is used.
OFF
Time Setting Specify the time of each day that the ma-
chine is turned on/off.
–
Date Setting Specify the individual dates or the days
of the week that the machine is turned
on/off.
–
Select Time for Power
Save
If the machine is turned off at a specific
time, for example, during the lunch
break, the time for turning the machine
off and on can be specified.
OFF
Password for Non-Busi-
ness Hours
If the machine is turned off with the
weekly timer function, select whether or
not use is limited with a password. In ad-
dition, if “ON” is selected, specify the
password that must be entered.
OFF
To Next Page
Loading...
Need help?
General
