12
Utility
12-54 C300
Utility Chapter 12
Adjusting the starting print position for the second side
The starting print position at the left edge of the paper for the second side
during automatic double-sided copying for each paper tray can be adjusted.
0 The starting print position is adjusted during manufacturing of the ma-
chine. Normally, this position will not need to be adjusted.
0 Only 8-1/2 × 11 v paper can be used to adjust the bypass tray.
1 Display the Administrator Setting screen.
– For details on displaying the Administrator Setting screen, refer to
“Displaying the Administrator Setting screen” on page 12-47.
2 Touch [1 System Setting].
The System Setting screen appears.
3 Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4 Touch [2 Printer Adjustment].
The Printer Adjustment screen appears.
5 Touch [3 Centering (Duplex 2nd Side)].
The Centering (Duplex 2nd Side) screen appears.
6 Touch the button for the paper tray to be set.
7 Press the [Start] key.
A test pattern is printed.
To Next Page
Loading...
Need help?
General
