SECTION 29 - HYDROSTATIC TRANSMISSION
29-92
6. Remove the right engine side shield to access
the check valve, 1.
7. Remove the return line at 2, and cap to prevent
the loss of oil.
8. Remove the check valve from the oil filter base
at 3.
The charge check valve is nonadjustable and not
serviceable. If the valve does not operate, it will
need to be replaced. The only procedure you can
perform on the valve is to clean the valve
assembly.
208
9. Remove the snap ring, 1. Disassemble and clean
the check valve.
10. The check valve is marked for oil flow for
installation.
209
Op. 29 100
STEERING SYSTEM
HYDROSTATIC SYSTEM CONTROLS
Before any control linkage adjustments or repairs are
made to the skid steer, do the following:
1. Lower the boom and bucket to the lowered
position, resting on the ground, or remove any
attachment and raise the boom and rest on the
boom lock pins, 1.
CAUTION
Never work under a raised boom unless it is
properly supported by the boom lock pins.
Never work under a raised boom with an
attachment. Always remove the attachment from
the loader.
2. Stop the engine, turn the ignition key to the run
position and operate the boom and bucket
control pedals to relieve pressure in the boom
and bucket circuits. Turn off the key.
210
To Next Page
Loading...
Need help?
General
