SECTION 10 - ENGINE
10-62
CRANKSHAFT AND BEARING HOLDER
ASSEMBLY
1. Install the bearing holders on the crankshaft.
Insert this in the bushing at the front end of the
cylinder block.
2. Align the bolt hole at the lower part of the cylinder
block with thread hole on the bearing holder and
tighten with bolts. For flywheel end, use two
special bolts, hex recess in its head.
Bearing holder tightening torque:
Hex hole bolts - 18 - 22 ft. lbs. (24 - 30 N·m)
Hex bolts - 36 - 40 ft. lbs. (49 - 54 N·m)
93
3. Measure crankshaft end float.
Standard Play:
0.004″ - 0.016″ (0.1 mm - 0.4
mm)
Allowable Limit:
0.020″ (0.5 mm)
94
REAR OIL SEAL
This is a press-fit, retained by the backplate.
95
To Next Page
Loading...
Need help?
General
