SECTION 33 - BRAKES AND CONTROLS
33-10
4. Slide the seat to the most rear position and un-
latch the seat pan and raise the seat and pan as-
sembly to the raised latched position.
CAUTION
Before working under a raised seat make sure it
is securely latched at 1, in the raised position.
12
5. Remove the rear tire and wheel from the final
drive and brake being serviced.
6. Clean the rear axle and final drive area to prevent
debris from entering the final drive case.
7. Loosen the eight axle housing retaining nuts and
washers, 1, on the rear axle and slide the axle for-
ward to loosen the drive chain.
8. Remove the fender retaining hardware at 2, and
remove the fender to access the spring and link-
age.
9. Remove the final drive case center cover, 3.
13
Op. 33 110 14
Brake Control Linkage Removal
1. Remove the handle retaining bolts, 1, slide the
handle, button and spring, and latch plate as-
sembly, 2, from the link, 3.
Note the positioning of the internal latch plate for
reassembly.
OPS5461
14
To Next Page
Loading...
Need help?
General
