SECTION 88 - ACCESSORIES
88-7
Op. 90 000
ARM PADS FOR CAB SIDE PANELS
The cab arm pads provide additional operator com-
fort and may be used separately or in combination
with the seat armrest.
The arm pads, 1, require gluing in place to the cab
side panels with Loctite

454 gel adhesive.
The area where the arm pads are to be located must
be cleaned thoroughly to ensure a secure bond to the
cab side panel. If the area is not cleaned, the adhesive
will not adhere to the metal side panels. Clean with
methyl ethyl ketone, isopropyl alcohol, or equivalent
cleaning solvent that will not leave a residue.
NOTE: Position arm pads quickly because the adhe-
sive begins to bond in a few seconds.
CAUTION
Read the adhesive label warnings. Loctite
)
454
gel is a superglue-type material and can bond
skin, eyes, etc. Use with adequate ventilation.
7
Op. 90 000
ARMRESTS FOR DELUXE SEAT
Right and left side armrests, 1, can be installed to the
back of the deluxe seat only, at 2, for operator com-
fort.
NOTE: The standard seat mounting holes are not
provided to attach the armrests.
There are two styles of armrest:
• Bolts attach armrests to the back of the steel
back seat support.
• Bolts attach armrests to the sides of the plastic
back seat supports.
8
Armrest Adjustment
The armrest can be adjusted up or down for operator
comfort by turning adjusting screws, 1.
9
To Next Page
Loading...
Need help?
General
