SECTION 55 - ELECTRICAL SYSTEM
55-106
HYDRAULIC OIL FILTER RESTRICTION
SWITCH
Op. 55 414 24
REMOVAL
1. Support the boom on the boom lock pins.
2. Open the rear door, raise the top engine shield
and remove the right engine side shield to access
the switch.
3. Remove the DKGN/O wire, 1.
4. Remove the restriction switch, 2, from the filter
base.
INSTALLATION
1. Install the switch into the filter base.
2. Attach the DKGN/O wire to the switch terminal.
2
134
HYDRAULIC OIL TEMPERATURE SENDER
Op. 55 414 20
REMOVAL
1. Remove any attachment from the boom face
plate and support the boom on the boom
lock pins.
CAUTION
Never work under a raised boom unless it is
properly supported by the boom lock pins.
2. Raise the operator’s seat and latch in the raised
latched position.
CAUTION
Never work under a raised seat unless it is
securely latched in the raised position.
3. Drain the hydraulic reservoir.
Remove the rear engine belly pan hardware, 1,
and lower the pan from the loader.
CAUTION
Use a floor jack to support the belly pan and
prevent serious injury.
135
To Next Page
Loading...
Need help?
General
