SECTION 33 - BRAKES AND CONTROLS
33-13
Installation of Brake Control Linkage
1. Install the control rod assembly, 1, friction pad, 2,
on right end of rod. Insert pivot bushing, 3, into
supports, and slide the right end into support and
pivot link, 3, up and install the left support, 4.
21
2. Insert the button rod, 1; spring, 2; and flat washer,
3, into lever at 4.
3. Insert the latch plate, 5, and bushing, 6, with the
extended area, 7, as shown to the rear (engine
side) of lever and position the button rod so the
hook is back of the latch plate at 8. Reinstall the
two retaining bolts, nuts and washers, through
the lever assembly and the control rod.
22
Spring Reassembly
1. Reassemble the spring, 1, rod weld assembly, 2,
and spring plate, 3.
2. Compress spring, 1, and plate, 3, enough to
clamp vise grips onto end of rod weld assembly
at 4, to install roll pin, 5.
3. Install roll pin, 5.
4. Thread rod assembly, 6, into rod weld assembly.
2
1
19995774
5
6
3
4
23
To Next Page
Loading...
Need help?
General
