SECTION 10 - ENGINE
10-23
Op. 10 001 10
ENGINE REMOVAL
The engine can be removed from the loader by two
methods:
Method 1: Removing the rear door, radiator, oil
cooler, and support as an assembly.
Method 2: Tilting the cab and boom forward to gain
access.
For either method, raise and support the boom on the
boom lock pins, 1, to access the engine area.
5
METHOD 1
(Without Tilting Cab)
1. Open rear door, 1. Remove the top engine hood,
2, and both the right and left engine side covers.
2. Remove the battery.
3. Drain the cooling system, radiator, and engine
block, 3.
4. Remove the upper and lower radiator hoses from
the engine block and plug the hoses with plastic
plugs.
6
5. Remove the air cleaner hose, 1, from the intake
manifold and cap.
6. Unplug the engine wire harness from the main
harness, 2, and ground wires from the engine
bellhousing, 3.
7. Unhook the control valve hydraulic oil return line
at the oil cooler and cap, 4.
7
To Next Page
Loading...
Need help?
General
