SECTION 35 - HYDRAULIC SYSTEM
35-64
12. Turn the suction tube fitting, 1, down and install
the suction tube, 2. Tighten all hydraulic connec-
tions securely.
19998082
2
1
93
HYDRAULIC SYSTEM PUMP AND HIGH
FLOW PUMP REASSEMBLY/ INSTALLATION
NOTE: If installing a new pump assembly, refer to
“New Hydraulic System Pump / High Flow Pump
Installation” below.
1. Coat all parts with a thin coat of petroleum jelly or
oil to aid in reassembly.
2. Clean the mounting plate surface and hydrostat-
ic pump housing thoroughly and install a new O
ring, 1.
19997782
1
94
3. Install the seal, 1, and backup gasket 2, on the
wear plate, 3. BE SURE that the flat area, 4, on
the gasket AND seal, 5, are properly aligned and
lay flat when installed in the wear plate.
95
To Next Page
Loading...
Need help?
General
