SECTION 55 - ELECTRICAL SYSTEM
55-83
SEAT AND SEAT BELT SWITCH WIRING
Ref Color Destination
Battery
Voltage
1 LTGN To EIC Board Pin
#11 (large connector)
Seat Belt
Buckled
2 T From Seat
Switch(es)
Sit in
Seat
3 T To Seat Belt switch Sit in
Seat
4 LTGN/R From Electronics 5A
Fuse (engine panel)
All Times
5 T To Service/Run
Switch
Sit in
Seat
93
Op. 55 201 15
SEAT SWITCH REMOVAL
1. Disconnect the negative (–) battery cable.
2. Raise the seat and securely latch in the raised
latched position, 1.
CAUTION
Never work under a raised seat unless it is
securely latched in the raised position.
3. Remove the seat retaining hardware, 2.
4. Holding the seat in place, lower the seat pan and
seat and unplug the seat switch(es).
5. Remove the seat from the loader.
6. Disconnect the wire harness from the switch(es)
by releasing the latch away from the switch.
1
4825-11r
2
94
7. Remove the switch(es) from the seat pan. The
standard seat uses one switch, 1, and the deluxe
seat uses two switches, 2.
95
To Next Page
Loading...
Need help?
General
