SECTION 33 - BRAKES AND CONTROLS
33-15
10. Remove brake friction puck, 1, and spacer plate,
2.
NOTE: The spacer plate is thinner than the friction
puck and must be inserted into brake caliper first
upon reassembly.
27
11. Remove the caliper support retaining bolt, 1, and
remove the support from the loader.
12. Remove the setscrew, 2, from the arm, 3, and
slide the arm from the shaft, 4.
13. Rotate the caliper shaft, 4, from the support.
28
Brake Caliper and Disc Parts Inspection
Thoroughly clean all parts of sealing material etc. be-
fore inspection.
Brake caliper and related parts
Ref. Description
1 Brake disc retaining hardware
2 Brake disc (2)
3 Brake puck (1)
4 Spacer plate (1)
5 Caliper support and hardware
6 Shaft
7 Center caliper plate
8 Bushings and hardware
9 Outer caliper section
29
To Next Page
Loading...
Need help?
General
