SECTION 29 - HYDROSTATIC TRANSMISSION
29-72
Slide the housing down over the complete shaft
assembly. Be sure the shaft extends through the
housing approximately 38 mm (1-1/2″). If the
shaft does not protrude through the housing the
distance shown, the spacer and/or pivot is
installed incorrectly.
154
7. Turn over the housing and clamp it in a vise on
the flanged end of the housing.
Inspect the piston block and the retaining ring to
be sure they are seated properly in the taper of
the block at 1.
155
Motor Shimming Procedure
1. Place a spring collar over the shaft and snap ring
at 1. Place the gauge block, 2, marked XDB-1756
or 74600-624 over the shaft and next to the collar
previously installed.
156
To Next Page
Loading...
Need help?
General
