SECTION 35 - HYDRAULIC SYSTEM
35-55
Op. 35 710 10
PUMP REMOVAL
1. Lower the boom and bucket to the lowered posi-
tion (resting on the ground), or remove any at-
tachment and raise the boom and rest on the
boom lock pins.
2. Stop the engine, turn the ignition key to the run
position and operate the boom and bucket con-
trol pedals to relieve pressure in the boom and
bucket circuits. Turn off the key.
3. Raise the seat and seat pan to the raised latched
position.
4. Remove the step shield, 1, to access the gear
pump area. For more access remove the right or
left hydrostatic control handle assembly.
CAUTION
Do not work under a raised seat unless it is
securely latched in the raised latched position.
Never work under a raised boom unless it is
properly supported by the boom lock pins.
Never work under a raised boom with an
attachment. Always remove the attachment from
the loader.
Never loosen any hydraulic lines without first
relieving all pressure in the system.
68
To Next Page
Loading...
Need help?
General
