SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)
82-29
20. Reinstall the boom mounting plate if removed.
Torque the pivot bolts, 1, to 108 N·m (80 ft. lbs.).
The tapered pivot pins and retaining hardware
must be hammer seated by striking the head of
the bolt and pin and retorquing the bolt. This step
must be repeated until the torque is maintained.
21. Reinstall any shields removed for the repair.
1
1
68
ATTACHMENT MOUNTING PLATE
Op. 82 100 70
REMOVAL
1. Remove any attachment from the loader attach-
ment mounting plate.
2. Lower the boom to the fully lowered position.
3. Tilt the attachment mounting plate forward until
the face is level with the ground.
4. Remove the cylinder attachment mounting plate
pivot pins by removing the pin retaining bolts, 1,
and sliding the pins from the mounting plate and
cylinders.
CAUTION
Support the mounting plate during removal to
prevent dropping the plate when pins are re-
moved.
5. Remove hub caps, 2, from the pivots.
6. Loosen the attachment mounting plate to boom
pivot pin hardware, 3. DO NOT remove the bolts
at this time.
7. With a soft-faced sledgehammer, strike the
mounting plate pivot area, 4. This will free the ta-
pered pivot pin in the boom link.
8. Remove the pivot pin retaining hardware and re-
move the tapered pins.
3
3
1
2
19984476
4
69
To Next Page
Loading...
Need help?
General
