SECTION 88 - ACCESSORIES
88-18
HIGH FLOW HYDRAULICS
COMPONENT REPLACEMENT
Op. 35 724
High Flow Selector Valve Replacement
To access the selector valve, 1, the seat must be
raised and latched in the raised position.
The left hydrostatic control lever assembly must be
removed.
The cab may be tilted forward for easier access.
1
27
Rebuild the selector valve with new O rings on the
spool and fittings at 1, and on both ends of the coil at
2.
To check the coil, use an ohmmeter and put one lead
on one wire and the other on the other wire; the ohms
reading should be between 7.5 and 11.5. If the coil is
not within specification, replace it.
28
To Next Page
Loading...
Need help?
General
