New Holland LS160 User Manual

SECTION 55 - ELECTRICAL SYSTEM
55-160
LABOR GUIDE
The following labor amounts are listed as a guide only. Working conditions and experience will vary the time it
actually takes to complete each job.
Job Description Hours
Air filter sensor, remove and replace 0.5 hr.
Alternator, remove and replace 0.5 hr.
Battery, remove and replace 0.25 hr.
Electronic instrument cluster 0.25 hr.
Engine coolant sensor, remove and replace 0.25 hr.
Engine oil pressure sender, remove and replace 0.25 hr.
Fuel level sender, remove and replace 0.5 hr.
Fuel pump, remove and replace 0.5 hr.
Fuel shutoff solenoid, remove and replace 0.25 hr.
Hydraulic oil temperature sensor, remove and replace 2.0 hrs.
Hydraulic oil filter sensor, remove and replace 0.5 hr.
Hydrostatic charge pressure sensor, remove and replace 0.5 hr.
Ignition (key) switch, remove and replace 0.25 hr.
Light (road/work) switch, remove and replace 0.25 hr.
Preheat manual switch, remove and replace 0.5 hr.
Preheat circuit breaker, remove and replace 0.5 hr.
Preheat relay, remove and replace 0.5 hr.
Resistor, alternator charge circuit, remove and replace 0.5 hr.
Road/work/taillight bulb, remove and replace 0.25 hr.
Seat belt (buckle) switch, remove and replace 0.25 hr.
Seat switch(es), remove and replace 0.5 hr.
Service/run switch, remove and replace 0.5 hr.
Solenoid, control valve spool locks, remove and replace 0.5 hr.
Start interlock relay, remove and replace 0.5 hr.
Starter, remove and replace 0.75 hr.
Starter relay, remove and replace 0.5 hr.
Wire harness (main), remove and replace 6.0 hrs.
Wire harness (engine), remove and replace 1.5 hrs.
Wire harness (seat/seat belt), remove and replace 1.0 hr.

New Holland LS160 Specifications

General

Brand	New Holland
Model	LS160
Category	Mini Skid Steers
Language	English