SECTION 33 - BRAKES AND CONTROLS
33-20
12. Reinstall the drive chain over the drive sprocket
at 1.
42
13. Install the rear axle assembly. Slide the axle as-
sembly to the rear and tighten the drive chain to
obtain a movement of 0 - 6 mm (0 - 1/4″) move-
ment at the outer tire tread.
Tighten the retaining bolts, 1, to 190 N·m (140 ft.
lbs.).
14. Reseal and install the final drive cover, 3.
15. Check the final drive case oil level and add as re-
quired, 4.
16. Reinstall fender, 5, and all other shields removed
for the repair.
43
Parking Brake and Linkage Adjustment
When the parking brake is properly adjusted and en-
gaged it will hold a powered loader.
Spring Adjustment
Parking brake in the disengaged position.
1. Measure the spring length from the top to the bot-
tom of the spring retainer at 1.
2. Adjust the spring assembly by threading rod, 2,
in or out to obtain an overall length of 8-5/8″ at 1.
19980499
2
1
44
To Next Page
Loading...
Need help?
General
