SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)
82-30
REPAIR/REBUILD MOUNTING PLATE
Op. 82 100 74
LATCH LEVER AND PIN REMOVAL/REPAIR
1. Remove any attachment from the loader attach-
ment mounting plate.
2. Lower the boom to the lowered position.
3. Tilt the attachment mounting plate forward until
the face is level with the ground.
4. With an allen wrench, remove the setscrew, 1,
from the backside of the mounting plate for both
the left and right sides.
19984477
1
19984477
70
5. Move the latch handle, 1, to align the groove pin
in the setscrew hole, 2. Drive out the groove pin
with a hammer and punch. Repeat this proce-
dure on other side.
6. Remove the latch pin from each side from the
bottom of the mounting plate.
2
1
1998447819984478
71
7. Remove the cylinder attachment mounting plate
pivot pins to allow access to the latch handle piv-
ot pin snap ring clips.
CAUTION
Support the mounting plate during removal of
the mounting plate pivot pins to prevent drop-
ping the plate down when pins are removed.
8. Remove the pin retaining bolts, 1, and slide the
pins from the mounting plate and cylinders.
1
1
19984476
72
To Next Page
Loading...
Need help?
General
