SECTION 33 - BRAKES AND CONTROLS
33-14
5. Adjust the spring assembly length by threading
rod, 1, in or out to obtain an overall length of
8-5/8″ at 2.
1
19980499
2
24
Op. 33 110 48
Brake Caliper and Disc Removal
The loader must be properly supported with all four
wheels off the ground.
1. Remove the rear axle assembly.
2. Remove the rear drive chain from the drive
sprocket and push chain to the rear.
3. Engage the parking brake.
4. Remove the center brake disc retaining bolt and
washer, 1.
5. Disengage the parking brake.
6. Loosen the caliper retaining hardware, 2, from
the inside of cab. Thread the two bolts from the
outside caliper assembly, 3. DO NOT remove
bolts from caliper support at this time.
7. Remove the outside disc, 4.
25
8. Remove center section of caliper, 1, spacers, 2,
and now remove the retaining bolts.
9. Remove inside disc, 3.
26
To Next Page
Loading...
Need help?
General
