SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)
82-18
BOOM, UPPER AND LOWER LINK
REMOVAL
1. Remove any attachment (bucket, fork, etc.) from
the boom mounting plate and lower the boom to
the lowered position.
36
2. Attach a chain or strap suitable for handling the
weight of the boom (approximately 800 lbs.) to
the boom grab handles as shown at 1. Support
the boom about level with the top of the loader
ROPS.
CAUTION
Always use a suitable lifting device and chains or
straps to support and remove the boom.
37
3. Support the rear of the boom with the rear lower
link pivot above the top of the engine shielding as
shown.
NOTE: This will enable the removal of the link pivot
hardware.
38
To Next Page
Loading...
Need help?
General
