SECTION 00 - GENERAL INFORMATION
00-19
CAB AND BOOM TILT PROCEDURE
The cab and boom assembly can be tilted forward for
easier access to the major skid steer hydrostatic
transmission or engine components. To tilt the cab,
the proper cab tilting tool must be used to ensure
safety and to prevent damage to the skid steer frame,
cab, and boom structure. Contact your New Holland
dealer for major service or repairs of the skid steer.
Using the proper cab tilting tool and following these
steps, the cab and boom can be tilted forward.
1. Remove any attachment, bucket, etc. from the
boom quick-attach plate.
17
Cab tilting jack and support brackets:
1 Jack and screw assembly
2 Lower support
3 Upper support
4 Spacer top link
18
2. Raise the boom and lower onto boom lock pins,
1.
– Raise boom above boom lock pins.
– Engage boom lock pins.
– Stop engine, ignition key off position.
– Turn ignition key to the on position.
– Lower boom onto boom lock pins.
– Turn the ignition key to the “OFF” position.
19
To Next Page
Loading...
Need help?
General
