SECTION 88 - ACCESSORIES
88-14
Op. 35 000
HIGH FLOW HYDRAULICS
When the high flow hydraulics circuit is used, it will al-
low the operator to utilize more available engine
horsepower through the auxiliary hydraulic circuit.
The high flow increases the hydraulic flow:
LS160
From 15.5 GPM, 1000 PSI at 2900 RPM to 24.0
GPM, 1000 PSI at 2900 RPM (= 32.2 HP).
LS170
From 17.7 GPM, 1000 PSI at 2900 RPM to 26.6
GPM, 1000 PSI at 2900 RPM (= 35.7 HP).
During warm climate operation, be conscious of the
EIC (Electronic Instrument Cluster) temperature
monitoring system. Adjust the attachment load (rate
of feed) and length of continuous operation (duty
cycle times) accordingly.
This high flow is not intended to replace a fully dedi-
cated, specialized machine.
23
When the attachment is not in use, be sure the high
flow switch, 1, is in the “OFF” position to prevent over-
heating of the hydraulic oil.
1
19987112
24
When the high-flow is being used, 3/4″ quick cou-
plers, 1, must be used on the loader and attachment
or overheating of the hydraulic oil may occur. The
1/2″ quick couplers, 2, can be used for other attach-
ments that do not require the added oil flow.
25
To Next Page
Loading...
Need help?
General
