SECTION 55 - ELECTRICAL SYSTEM
55-130
ALTERNATOR
Op. 55 301 10
ALTERNATOR REMOVAL
1. Open the rear door, 1, raise the top engine shield,
2, and remove the right engine side shield, 3, to
access the alternator.
2. For easier access, remove any attachment from
the loader boom face plate and raise the boom
and rest it on the boom lock pins.
CAUTION
Never work under a raised boom unless it is
properly supported by the boom lock pins.
Never work under a raised boom with an
attachment. Always remove the attachment from
the loader.
3. Disconnect the negative (–) battery cable to
prevent possible damage to the alternator and
electrical system.
4. Disconnect the wire connections from the
alternator noting their location.
1
1
2512-08
3
2
178
5. Remove the top strap retaining hardware, 1, and
lower pivot, 2.
179
To Next Page
Loading...
Need help?
General
