SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)
82-4
Op. 82 100 70
ATTACHMENT MOUNTING PLATE
The attaching plate is attached to the main boom
frame with two tapered pivot pins. The attachments
used on the skid steer can be easily attached or re-
moved from the loader with the over center levers
and pins. The control levers and pins are spring
loaded to hold the levers over center when unlatched
to assist in changing attachments. When the control
levers are in the latched position the spring-loaded
pins are forced into the latch points on the attach-
ment. The control levers and pins are shown in the
latched position.
5
BOOM AND CYLINDER PIVOT PINS
When the boom, upper and lower boom links and cyl-
inders are removed, the following figures and charts
may be use for proper pin placement. The following
charts and figures list the pivot pin, part number, loca-
tion, and size for identification and locations.
6
6
BOOM AND CYLINDER PIVOT PIN LOCATION AND MACHINE USAGE
Ref.#
Description Qty.
Part Number
Torque
1 Mounting Plate Pivot 2 86501434 108 N·m (80 ft. lbs.)
2 Upper Bucket Cylinder Pivot 2 86501430 108 N·m (80 ft. lbs.)
3 Lower Bucket Cylinder Pivot 2 9614349 38 N·m (28 ft. lbs.)
4 Upper boom Cylinder Pivot 2 86521982 38 N·m (28 ft. lbs.)
5 Lower boom Cylinder Pivot 2 86504316 338 N·m (250 ft. lbs.)
6 Boom Lower Link Pivot 4 86501422 338 N·m (250 ft. lbs.)
7 Boom Upper Link Pivot 4 86501420 338 N·m (250 ft. lbs.)
To Next Page
Loading...
Need help?
General
