Polaris RANGER XP 1000 2018 User Manual

4
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
4.35
ECT SENSOR REPLACEMENT
1. Lift the rear cargo box to the raised position.
2. Drain the coolant so the level is below the sensor.
Refer to COOLANT DRAIN / FILL procedure.
3. Remove the fuel line from fuel rail. Refer to FUEL
LINE REMOVAL / INSTALLATION procedure
4. Disconnect the vehicle harness
q
from the ECT
sensor.
5. Using a wrench, loosen and remove ECT sensor from
engine.
6. Apply thread sealant to the new sensor threads and
install it into the cylinder head.
7. Torque the new ECT sensor to specification and
connect the vehicle harness to the sensor.
TORQUE
ECT Sensor:
16 ft-lbs (22 Nm)
8. Reconnect the fuel line to the fuel rail.
9. Add the required amount of coolant and bleed the
system. Refer to COOLING SYSTEM BLEEDING
PROCEDURE.
FUEL SYSTEM

Polaris RANGER XP 1000 2018 Specifications

General

Brand	Polaris
Model	RANGER XP 1000 2018
Category	Utility Vehicle
Language	English