M126/M127/M128 5-12 SM
5.2.14 FORMAT FAX STORAGE
This setting enables you to format the non-volatile storage used for storing faxes.
To change this setting:
1. Touch "Format Fax Storage" from the Configuration Menu.
 If an advanced password has been established, you must enter this password in
order to change the setting. If no advanced password exists, you can establish one
by using the keyboard that appears on the LCD.
2. Touch "Submit" to save the change.
3. Touch "Back" to cancel and return to the Configuration Menu.
"Formatting Fax Flash DO NOT POWER OFF" appears on the LCD while the format operation is
active.
5.2.15 FAX STORAGE LOCATION
To change this setting:
1. Touch "Fax Storage Location" from the Configuration Menu. [setting's current value]
appears on the touch-screen.
2. Touch
or . The settings are Disk and NAND.
3. Touch "Submit" to save the change.
5.2.16 ADF EDGE ERASE
This menu item sets the size, in millimeters, of the no-print area around an ADF scan job. All copy
jobs have a minimum of a two millimeter border. Copy jobs will use the setting or two millimeters,
whichever is larger.
To adjust the ADF edge erase setting, perform the following steps:
1. Touch "ADF Edge Erase" from the Configuration Menu.
[setting's current value]
appears on the touch-screen.
2. Touch
to increase the value or to decrease the value.
3. Touch "Submit" to save the change.
4. Touch "Back" to cancel and return to the Configuration Menu.
To Next Page
Loading...
Need help?
General
