Power Assisted Steering System: 6C-11
Installation
1) Install tie-rod end lock nut (3) and tie-rod end (4) to
tie-rod (1). Tighten lock nut (3) to mark (2) on tie-rod
thread.
2) Install tie-rod end (4) to knuckle (5). Tighten new tie-
rod end nut (6) to specified torque.
Tightening torque
Tie-rod end nut (a): 43 N·m (4.3 kgf-m, 31.0 lb-ft)
3) After installing wheels, lower vehicle and tighten
wheel nuts to specified torque.
Tightening torque
Wheel nut (a): 100 N·m (10.0 kgf-m, 72.5 lb-ft)
4) Check that proper amount of toe-in is obtained
referring to “Front Wheel Alignment Inspection and
Adjustment: in Section 2B”.
5) After confirming proper amount of toe-in, tighten tie-
rod end lock nut to specified torque.
Tightening torque
Tie-rod end lock nut (a): 65 N·m (6.5 kgf-m, 47.0
lb-ft)
Tie-Rod End Ball Joint Inspection
S5JB0A6306008
Inspect for play in tie-rod end ball joint (1). If found
defective, replace.
IYSQ01630018-01
IYSQ01630019-01
IYSQ01630020-01
IYSQ01630021-01
To Next Page
Loading...
Need help?
General
