9B-18 Lighting Systems:
Other Than Discharge Headlight Bulb
1) Disconnect negative (–) cable at battery.
2) Disconnect coupler from bulb (1).
3) Remove socket cover (2) (if equipped).
4) Replace bulb and assemble all removed parts.
Ballast Removal and Installation
S5JB0A9206023
WARNING
!
Be sure to read “Precautions for Discharge
Headlight Service (If Equipped): ” carefully
before working. Neglecting them may result
in personal injury.
Removal
1) Check to ensure that lighting switch is at OFF
position.
2) Disconnect negative (–) cable at battery.
3) Remove headlight housing referring to “Headlight
Housing Removal and Installation: ”.
4) Remove ballast (1) from headlight housing (2).
5) Disconnect connector (3) from ballast.
Installation
Reverse removal procedure noting the following.
• Connect connectors securely.
• After installation, be sure to inspect and adjust aiming
referring to “Headlight Aiming Adjustment with
Screen: ”.
[A]: 3door model or low beam of 5door model
[B]: High beam of 5door model
2
1
2
iii)
ii)
i)
ii)
i)
[B]
[A]
I5JB0A920018-01
1
2
3
I5JB0A920019-01
To Next Page
Loading...
Need help?
General
