4A-3 Brake Control System and Diagnosis:
Rear Brake Hose / Pipe Construction
S5JB0A4101007
Master Cylinder Assembly Construction
S5JB0A4101003
The master cylinder has two pistons, two pressure seal (3) and two separating seal (4). Its hydraulic pressure is
produced in the primary (A in the figure) and secondary (B) chambers. The hydraulic pressure produced in the primary
chamber (A) acts on the front right and rear left brakes.
Also, the hydraulic pressure produced in the secondary chamber (B) acts on the front left and rear right brakes.
WARNING
!
Brake master cylinder cannot be disassembled. When anything faulty is found in it, it must be replaced
as an assembly.
CAUTION
!
Brake master cylinder cannot be disassembled in principle. Should primary piston (1) have come off
from cylinder while dismounting or handling it, wash it in the same specified fluid as that in reservoir
and place it back in cylinder.
I5JB0A410003-02
1. To left rear brake hose 3. Left rear brake hose
2. To right rear brake hose 4. Right rear brake hose
To Next Page
Loading...
Need help?
General
