Rear Suspension: 2C-27
Rear Wheel Hub Assembly, Wheel Bearing and
Wheel Stud Inspection
S5JB0A2306020
• Wheel bearing and wheel hub form a solid unit.
• When wheel bearing is found defective and its
replacement is necessary, replace hub assembly.
Rear Wheel Disc, Nut and Bearing Check
S5JB0A2306021
• Inspect each wheel disc for dents, distortion and
cracks.
A disc in badly damaged condition must be replaced.
• Check wheel nuts for tightness and, as necessary,
retighten to specification.
Tightening torque
Wheel nut (a): 100 N·m (10.0 kgf-m, 72.5 lb-ft)
• Check wheel bearings for wear. When measuring
thrust play, apply a dial gauge to spindle cap center. If
thrust play exceeds limit, replace bearing.
Thrust play limit
“a”: 0.1 mm (0.004 in.)
• By rotating wheel actually, check wheel bearing for
noise and smooth rotation. If it is defective, replace
bearing.
I5JB0A230066-01
(a)
I5JB0A220029-01
I2RH01230011-01
I2RH01230012-01
To Next Page
Loading...
Need help?
General
