4B-3 Front Brakes:
Front Disc Brake Pad On-Vehicle Check
S5JB0A4206001
Inspect pad linings periodically according to
maintenance schedule whenever wheels are removed
(for tire rotation or other reason). Take a look through
hole of caliper and check lining thickness of outside and
inside pads.
If one of brake pad is worn to service limit, all linings
must be replaced at the same time.
Front brake pad thickness “a”
Standard: 11.0 mm (0.43 in.)
Limit: 2.0 mm (0.08 in.)
Front Disc Brake Pad Removal and Installation
S5JB0A4206002
Removal
1) Hoist vehicle and remove front wheel.
2) Remove caliper pin bolts (2).
3) Remove caliper (1) from caliper carrier.
NOTE
Hang removed caliper (1) with a wire hook (2)
or the like so as to prevent brake hose from
bending and twisting excessively or being
pulled. Don’t operate brake pedal with pads
removed.
4) Remove pads (3).
Installation
1) Install pad spring (1) and pads (2).
NOTE
Install brake pad with wear indicator (5) to
vehicle center side on right wheel brake.
1. Pad rim 3. Disc
2. Lining
1. Caliper
3. Disc
3
1
1
2
I5JB0A420002-01
3
1
2
I5JB0A420003-01
3. Disc 6. Shim
4. Caliper carrier
I1SQ01420004-01
5
2
2
1
3
4
6
6
6
I5JB0A420004-01
To Next Page
Loading...
Need help?
General
