Suzuki GRAND VITARA User Manual

9D-13 Wipers / Washers:
Rear Wiper Relay Inspection
S5JB0A9406013
1) Check that there is no continuity between terminal
“4” and “5”. If there is continuity, replace relay.
2) Check that there is continuity between terminal “3”
and “5”. If there is no continuity, replace relay.
3) Connect battery positive (+) terminal to terminal “2”
of relay.
4) Connect battery negative (–) terminal to terminal “1”
of relay.
5) Check continuity between terminal “4” and “5”. If
there is no continuity when relay is connected to the
battery, replace relay.
Headlight Washer Switch Inspection (If
Equipped)
S5JB0A9406014
Check for continuity between terminals at each switch
position.
If check result is not as specified, replace switch.
Headlight Washer Pump Removal and
Installation (If Equipped)
S5JB0A9406015
Removal
1) Remove front bumper referring to “Front Bumper
Components: in Section 9K”.
2) Disconnect headlight washer hose (1) and washer
pump connector (2) from headlight washer pump (3).
3) Remove headlight washer pump from washer tank.
Installation
Reverse removal procedure for installation.
Headlight Washer Nozzle Removal and
Installation (If Equipped)
S5JB0A9406016
Removal
1) Remove front bumper referring to “Front Bumper
Components: in Section 9K”.
2) Disconnect headlight washer hose (1) from headlight
washer nozzle (2).
3) Remove headlight washer nozzle from front bumper.
Installation
Reverse removal procedure for installation.
“5”
“2”
“1”
“4”
“3”
I5JB0A940022-01
1
2
3
4
Switch Position
Terminal
ON (PUSH IN)
12
3
4
OFF
I5JB0A940023-01
1
2
3
I5JB0A940024-01
2
1
I5JB0A940025-01

Suzuki GRAND VITARA Specifications

General

Brand	Suzuki
Model	GRAND VITARA
Category	Automobile
Language	English