2B-18 Front Suspension:
Front Suspension Frame, Stabilizer Bar and/or
Bushings Removal and Installation
S5JB0A2206015
Removal
1) Hoist vehicle and remove wheels (right & left).
2) Remove engine under cover.
3) Remove suspension control arm referring to
“Suspension Control Arm Removal and Installation:
”.
4) Remove right side and left side front drive shaft
assembly referring to “Front Drive Shaft Assembly
Removal and Installation: Front in Section 3A”.
5) Remove stabilizer joints (1). When loosening joint
nut, hold stud with hexagon wrench.
6) Disconnect front fender lining clip (1) (if equipped
with head light auto leveling system).
7) Disconnect front height sensor connector (1) (if
equipped with head light auto leveling system) and
then detach clip (2).
8) Disconnect steering lower shaft from pinion shaft
referring to “P/S Gear Case Assembly Removal and
Installation: in Section 6C”.
9) Detach low pressure return hose (2) from low
pressure return pipe (3) and then disconnect pipe
bracket (1).
10) Remove gear box union bolt (1).
1
1
I5JB0A220041-01
1
I5JB0A220042-01
1
2
I5JB0A220043-01
1
23
I5JB0A220044-01
1
I5JB0A220045-01
To Next Page
Loading...
Need help?
General
