1E-16 Engine Lubrication System: For J20 Engine
4) Install new gasket and drain plug (2) to oil pan after
applying engine oil.
Tighten drain plug to specified torque.
Tightening torque
Oil drain plug (c): 35 N·m (3.5 kgf-m, 25.5 lb-ft)
5) Install front suspension frame referring to “Front
Suspension Frame, Stabilizer Bar and/or Bushings
Removal and Installation: in Section 2B”.
6) Install engine under cover.
7) Install oil level gauge.
8) Refill engine with engine oil referring to “Engine Oil
and Filter Change: in Section 0B”.
Oil Pan and Oil Pump Strainer Cleaning
S5JB0A1526003
• Clean mating surface of oil pan and cylinder block.
Remove oil, old sealant and dust from mating
surfaces and oil pan inside.
• Clean oil pump strainer screen.
Oil Pump Components
S5JB0A1526004
(a)
1
2, (c)
(b)
I5JB0A152009-01
I5JB0A152010-02
1. Cylinder block 6. Oil pump mounting bolt (M8 bolt) 11. Oil pump chain guide nut : 25 N⋅m (2.5 kgf-m, 18.0 lb-ft)
2. Oil pump relief valve set
: Replace as a set.
7. Oil pump case bolt 12. Oil pump case No.1 : 12 N⋅m (1.2 kgf-m, 9.0 lb-ft)
3. Baffle plate 8. Oil pump relief valve retainer 13. Oil pump case No.2 : 28 N⋅m (2.5 kgf-m, 20.5 lb-ft)
4. Pin No.1 9. Oil pump chain guide 14. Pin No.3 : 11 N⋅m (1.1 kgf-m, 8.0 lb-ft)
5. Pin No.2 10. Oil pump chain guide plate 15. Baffle plate bolt (M6 bolt) : 11 N⋅m (1.1 kgf-m, 8.0 lb-ft)
To Next Page
Loading...
Need help?
General
