Automatic Transmission/Transaxle: 5A-67
DTC P1778: TCM Lost Communication with BCM (Reception Error)
S5JB0A5104059
Wiring Diagram
Refer to “DTC P1774: CAN Communication Bus Off: ”.
DTC Detecting Condition and Trouble Area
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch turned OFF.
2) Turn ON ignition switch and clear DTC by using scan tool.
3) Start engine and run it for 1 min. or more.
4) Check DTC and pending DTC.
DTC Troubleshooting
NOTE
Upon completion of inspection and repair work, perform “DTC Confirmation Procedure: ”“DTC
Confirmation Procedure” and confirm that the trouble has been corrected.
DTC Detecting Condition Trouble Area
Reception error of communication data for BCM is detected for
longer than specified time continuously.
(1 driving cycle detection logic)
•BCM
•TCM
• CAN communication line circuit
Step Action Yes No
1 Was “A/T System Check” performed? Go to Step 2. Go to “A/T System
Check: ”.
2 Control module connector check
1) Check connection of connectors of all control modules
communicating by means of CAN.
2) Recheck DTC in TCM referring to “DTC Check: ”.
Is there DTC P1778?
Go to Step 3. Intermittent trouble.
Check for intermittent
referring to “Intermittent
and Poor Connection
Inspection: in Section
00”.
3 DTC check in BCM (bus off)
1) Check DTC in BCM referring to “DTC Check: in Section
10B”.
Is there DTC U1073?
Go to “DTC U1073 (No.
1073): Control Module
Communication Bus
Off: in Section 10B”.
Go to Step 4.
4 DTC check
1) Check DTC in ECM referring to “DTC Check: in Section
1A”.
Is there DTC P1678?
Check BCM power and
ground circuit. If circuit
is OK, substitute a
known-good BCM and
recheck.
Go to Step 5.
5 CAN communication circuit check
1) Turn ignition switch to OFF position.
2) Disconnect connectors of all control modules
communicating by means of CAN.
3) Check CAN communication circuit between control
modules for open, short and high resistance.
Is each CAN communication circuit in good condition?
Check TCM power and
ground circuit. If circuit
is OK, substitute a
known-good TCM and
recheck.
Repair circuit.
To Next Page
Loading...
Need help?
General
