4C-6 Rear Brakes:
4) Install brake adjuster (2) and upper shoe return
spring (1).
5) Install adjuster pawl lever (3) and adjuster spring.
6) For procedure hereafter, refer to “Rear Brake Drum
Removal and Installation: ”.
Rear Brake Shoe Inspection
S5JB0A4306007
Parking Brake Shoe Lever
Inspect brake shoe lever for free movement against
brake shoe web. If defective, correct or replace.
Brake Adjuster
Check thread or ratchet of adjuster for wear, sticking and
corrosion.
If found defective, replace brake adjuster.
Springs
Inspect for damage or weakening.
Inspect each part with arrow for rust. If found defective,
replace.
Brake Shoe
Refer to “Rear Brake Drum and Shoe Inspection: ”.
Wheel Cylinder Removal and Installation
S5JB0A4306008
Removal
1) Remove brake drum referring to “Rear Brake Drum
Removal and Installation: ”.
2) Remove brake shoe referring to “Rear Brake Shoe
Removal and Installation: ”.
3) Loosen brake pipe flare nut (1) but only within the
extent that fluid does not leak.
4) Remove wheel cylinder mounting bolts (2).
Disconnect brake pipe from wheel cylinder and put
wheel cylinder bleeder plug cap (3) onto pipe to
prevent fluid from spilling.
4. Brake shoe
5. Lower shoe return spring
3
2
4
1
4
5
I5JB0A430006-01
I5JB0A430009-02
I5JB0A430011-01
I5JB0A430012-02
3
2
1
I5JB0A430013-01