5A-52 Automatic Transmission/Transaxle:
DTC P0717 Input / Turbine Speed Sensor Circuit No Signal
S5JB0A5104031
Wiring Diagram
DTC Detecting Condition and Trouble Area
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch OFF.
2) Clear DTCs in TCM and ECM memories by using scan tool.
3) Start engine and shift select lever to “D” range.
4) Start vehicle and increase vehicle speed to about 40 km/h (25 mile/h) for 3 minutes or more.
5) Stop vehicle.
6) Check DTC, pending DTC and freeze-frame data.
DTC Troubleshooting
BLU
PNK
1
2
2.5V
E93-6
E93-16
65
16 15 14 13 12 11
43
24 23 2122
10 9 8 7
21
1920 18 17
E92
17 16
26 25
15 14
65 342
13 12
23 2224
11 10 9
21 20 19
87
18
1
E93
3
I5JB0A510022-01
1. TCM 3. Terminal arrangement of TCM connector (viewed from harness side)
2. Input shaft speed sensor
DTC Detecting Condition Trouble Area
No pulse signal of input shaft speed sensor is inputted for 5
pulses period of output shaft speed sensor through it is
detected more than 600 rpm.
(1 driving cycle detection logic)
• Input shaft speed sensor or its circuit malfunction.
• Improper input shaft speed sensor installation.
• Damaged clutch drum.
• Foreign material attachment to sensor or drum.
•TCM
Step Action Yes No
1 Was “A/T System Check” performed? Go to Step 2. Go to “A/T System
Check: ”.
2 Check input shaft speed sensor circuit
1) Disconnect TCM connectors with ignition switch OFF.
2) Check for proper connection to input shaft speed sensor
at “E93-6” and “E93-16” terminals.
3) If OK, check resistance of sensor circuit.
Resistance of input shaft speed sensor circuit
Between terminals “E93-6” and “E93-16” of
disconnected harness side TCM connector: 560 –
680 Ω at 20 °C (68 °F)
Between terminals “E93-16” of disconnected
harness side TCM connector and ground: No
continuity
Are check results satisfactory?
Go to Step 4. Go to Step 3.
To Next Page
Loading...
Need help?
General
