Keyless Start System: 10E-12
DTC Clearance
S5JB0AA504009
1) Perform Steps 1) through 5) of DTC check procedure
and have DTC indicated.
2) Open driver side door.
3) Close driver side door and within 10 seconds after
that, perform Steps a) to c) described below.
a) Push unlock side (3) of driver side manual door
lock switch (1).
b) Push lock side (2) of driver side manual door
lock switch.
c) Repeat Steps a) and b) 3 times.
At the end of Step c), DTCs are cleared and key
indicator lamp indicates DTC No. 12 (Normal).
4) After completing DTC clearance, remove ignition key
from ignition key cylinder.
Keyless Start System Symptom Diagnosis
S5JB0AA504010
Door Lock Function of Keyless Start System
NOTE
Before performing trouble diagnosis procedure for door lock function of keyless start system, check
that power door lock system operates properly referring to “Power Door Lock System Operation
Inspection: in Section 9F”. If power door lock system does not operate properly, go to “Power Door
Lock System Symptom Diagnosis: in Section 9F”.
1
2
3
I5JB0AA50009-02
Condition Possible cause Correction / Reference Item
All doors can not be
locked / unlocked by all of
door request switches
Circuit fuse(s) blown Replace fuse(s) and check for short circuit.
Remote controller battery dead Replace battery.
Remote controller faulty Check remote controller for operation referring
to “Remote Controller Inspection: ”.
Wiring or grounding faulty Repair circuit.
Antennas or keyless start control
module faulty
Check input and output signals of Keyless start
control module referring to “Inspection of
Keyless Start Control Module and Its Circuits:
”.
BCM faulty Check input and output signal of BCM referring
to “Inspection of BCM and its Circuits: in
Section 10B”.
All doors can not be
locked / unlocked by any
one of door request
switch
Request switch faulty Check request switch for operation referring to
“Front Door (Driver and Passenger Side) Rear
End Door Request Switch Inspection: ”.
Wiring or grounding faulty Repair circuit.
Antennas or Keyless start control
module faulty
Check input and output signals of Keyless start
control module referring to “Inspection of
Keyless Start Control Module and Its Circuits:
”.
BCM faulty Check input and output signal of BCM referring
to “Inspection of BCM and its Circuits: in
Section 10B”.