4A-13 Brake Control System and Diagnosis:
Master Cylinder Reservoir Removal and
Installation
S5JB0A4106013
CAUTION
!
Do not allow brake fluid to get on painted
surfaces. Painted surfaces will be damaged
by brake fluid, flush it with water immediately
if any fluid is spilled.
Removal
1) Disconnect reservoir lead wire at coupler (1).
2) Clean outside of reservoir (2) and master cylinder
(3).
3) Take out fluid with syringe or such.
4) Disconnect clutch reservoir hose (1) from reservoir
(2) for M/T vehicle.
5) Remove reservoir connector pin (1) by using special
tool and then reservoir.
Special tool
(A): 09916–44310
Installation
1) When using new grommets (3), lubricate them with
the same fluid as the one to fill reservoir (1) with.
Then press-fit grommets (3) to master cylinder (2).
Grommets (3) must be seated in place.
2) Install reservoir (1) and drive in reservoir connector
pin (2) by using special tool (A). till both of its ends at
the right and left of reservoir becomes the same
length.
Special tool
(A): 09916–44310
3) Connect clutch reservoir hose (1) to reservoir (2) for
M/T vehicle.
4) Connect reservoir lead wire at coupler.
5) Fill reservoir with specified fluid.
6) After installing, bleed air from clutch system,
referring to “Air Bleeding of Brake System: ”.
7) Upon completion of installation, check for fluid
leakage.
3
2
1
I5JB0A410011-02
2
1
I5JB0A410012-02
1
(A)
I5JB0A410013-02
1
2
3
3
I5JB0A410014-01
I5JB0A410015-01
2
1
I5JB0A410012-02
To Next Page
Loading...
Need help?
General
