1I-10 Starting System:
Specifications
Starting Motor Specifications
S5JB0A1907001
1.2 kW Type [1.4 kW Type]
Tightening Torque Specifications
S5JB0A1907002
NOTE
The specified tightening torque is also described in the following.
“Starting Motor Dismounting and Remounting: ”
“Starting Motor Components: ”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Fastener Information: in Section 0A”.
Special Tools and Equipment
Recommended Service Material
S5JB0A1908001
NOTE
Required service material is also described in the following.
“Starting Motor Components: ”
Voltage 12 volts
Output 1.2 kW [1.4 kW]
Rating 30 seconds
Direction of rotation Clockwise as viewed from pinion side
Brush length Standard: 12.3 mm (0.48 in.) Limit: 5.5 mm (0.22 in.)
Number of pinion teeth 8
Performance Condition Guarantee
Around
at 20 °C (68 °F)
No load characteristic 11.0 V
90 A maximum
2370 r/min minimum [2000 r/min minimum]
Load characteristic
7.5 V
300 A
10.65 N⋅m (1.065 kgf-m, 7.70 lb-ft) minimum
[11.0 N⋅m (1.1 kgf-m, 7.95 lb-ft) minimum]
840 r/min minimum
Locked characteristic
4.0 V
[3.0 V]
780 A maximum
[860 A maximum]
20 N⋅m (2.0 kgf-m, 14.5 lb-ft) minimum
Magnetic switch operating voltage 8 volts maximum
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Starting motor battery cable nut 11 1.1 8.0 )
To Next Page
Loading...
Need help?
General
