0A-3 General Information:
Wire Color Symbols
S5JB0A0101004
There are two kinds of colored wire used in this vehicle.
One is single-colored wire and the other is dual-colored
(striped) wire. As the color symbol, the single-colored
wire uses only one, three or five alphabets (i.e. “G” or
“GRN”); the dual-colored wire uses two color symbols
combination (i.e. “G/Y” or “GRN/YEL”). The first symbol
represents the base color of the wire (“G” or “GRN” in
the figure) and the second symbol represents the color
of the stripe (“Y” or “YEL” in the figure).
Fastener Information
S5JB0A0101005
Metric Fasteners
Most of the fasteners used for this vehicle are metric. When replacing any fasteners, it is most important that
replacement fasteners be the correct diameter, thread pitch and strength.
Fastener Strength Identification
Most commonly used metric fastener strength property classes are 4T, 6.8, 7T, 8.8 and radial line with the class
identification embossed on the head of each bolt. Some metric nuts will be marked with punch, 6 or 8 mark strength
identification on the nut face. Figure shows the different strength markings.
When replacing metric fasteners, be careful to use bolts and nuts of the same strength or greater than the original
fasteners (the same number marking or higher). It is likewise important to select replacement fasteners of the correct
diameter and thread pitch. Correct replacement bolts and nuts are available through the parts division.
Metric bolts: Identification class numbers or marks correspond to bolt strength (increasing numbers represent
increasing strength).
Symbol Wire Color
B BLK Black
Bl BLU Blue
Br BRN Brown
GGRN Green
Gr GRY Gray
Lbl LT BLU Light blue
Lg LT GRN Light green
O, Or ORN Orange
RRED Red
W WHT White
Y YEL Yellow
PPNK Pink
V PPL Violet (Purple)
I1SQ01010037-01
I1SQ01010003-01
1. Nut strength identification
To Next Page
Loading...
Need help?
General
