Charging System: 1J-9
Water Pump and Generator Drive Belt On-Vehicle Inspection (For J20 Engine)
S5JB0A1A06013
[Type A]
1) Disconnect negative cable at battery.
2) Inspect belt for cracks, cuts, deformation, wear and cleanliness. If any of above conditions are found, replace belt,
referring to “Water Pump and Generator Drive Belt Removal and Installation (For J20 Engine): ”.
3) Make sure that tension indicator “A” is within the range “a”.
If indicator “A” comes into the NG range “c” passing “b”, replace generator belt with a new one.
NOTE
Use mirror when checking belt tension.
[Type B]
• Inspect belt for cracks, cuts, deformation, wear and cleanliness. If any of these conditions are found, replace belt,
referring to “Water Pump and Generator Drive Belt Removal and Installation (For J20 Engine): ”.
• Check to make sure that tension indicators are as follows in the figure by using mirror.
a. If the tension indicator “B” is found to the left of the indicator “A”, replace the generator belt.
b. If new generator belt has been installed, indicator “A” should be within “a” of the figure.
If it isn’t, it means that belt is not installed properly.
Reinstall it properly.
I1SQ01020003-01
I5JB0A1A0010-01
1. Water pump and generator drive belt 3. Water pump pulley 5. Tensioner
2. Crankshaft pulley 4. Tension pulley 6. Power steering pump pulley
To Next Page
Loading...
Need help?
General
