Engine General Information and Diagnosis: 1A-132
4 Was terminal “Vout” voltage in Step 3 within specification? Go to Step 5. “WHT/RED” wire is
open or shorted to
ground / power supply
circuit.
If wire and connection
are OK, substitute a
known-good ECM and
recheck.
5 Ground circuit check
1) Turn ignition switch to OFF position.
2) Measure resistance between “BLK/YEL” wire terminal of
CMP sensor connector and engine ground.
Is measured resistance value less than 3
Ω
?
Go to Step 6. “BLK/YEL” wire is open
or high resistance
circuit.
6 Was terminal “B+” voltage in Step 3 within specification? Go to Step 7. “BLU/BLK” wire is open
circuit. If wire and
connection are OK,
substitute a known-
good ECM and recheck.
7 CMP sensor check
1) Check CMP sensor and signal rotor tooth referring to
“Camshaft Position (CMP) Sensor Inspection: in Section
1C”.
Is check result satisfactory?
Substitute a known-
good ECM and recheck.
Replace CMP sensor
and/or intake camshaft.
Step Action Yes No
To Next Page
Loading...
Need help?
General
