Suzuki GRAND VITARA User Manual

1A-137 Engine General Information and Diagnosis:
4 Wire circuit check
1) With ignition switch turned OFF, measure resistance
between engine ground and each “YEL/BLK”, “YEL/
RED”, “YEL/GRN”, “YEL” wire terminals of EGR valve
connector.
Is resistance infinity?
Go to Step 5. Faulty wire(s) are
shorted to ground
circuit.
If wires are OK,
substitute a known-
good ECM and recheck.
5 Short circuit check for EGR valve control circuit
1) With ignition turned OFF, measure resistance between
each EGR valve control circuit wire (“YEL/BLK”, “YEL/
RED”, “YEL/GRN” and “YEL” wire) and each EGR valve
control circuit wire.
Is each resistance infinity?
Go to Step 6. Faulty wire(s) are short
circuit.
6 EGR valve stepper motor coil circuit check
1) With ignition switch turned OFF, connect EGR valve
connector.
2) Measure resistance between “E23-1/16” and each “C37-
3”, “C37-4”, “C37-5”, “C37-6” terminals of ECM
connector.
Is each resistance 20 – 31
Ω at 20 ° C, 68 ° F?
Faulty ECM. Substitute
a known-good ECM and
recheck.
Go to Step 7.
7 EGR valve check
1) Check EGR valve resistance referring to “EGR Valve
Inspection: in Section 1B”.
Is resistance within specified value?
Faulty wire(s) are open
or high resistance
circuit. If wires are OK,
substitute a known-
good ECM and recheck.
Faulty EGR valve.
Step Action Yes No

Suzuki GRAND VITARA Specifications

General

Brand	Suzuki
Model	GRAND VITARA
Category	Automobile
Language	English