Front Suspension: 2B-23
Stabilizer Joint
1) Check for smooth rotation.
2) Check damages of ball stud.
3) Check damages of dust cover.
NOTE
Stabilizer joint (1) cannot be disassembled.
If there is any damage to either parts, stabilizer joint
assembly must be replaced as a complete unit.
Front Suspension Fasteners Check
S5JB0A2206018
Check each bolt and nut fastening suspension parts for
tightness. Tighten loose one, if any, to specified torque,
referring to “Front Suspension Construction: ”.
Specifications
Tightening Torque Specifications
S5JB0A2207001
NOTE
The specified tightening torque is also described in the following.
“Front Suspension Construction: ”
“Front Strut Assembly Components: ”
“Front Wheel Hub Assembly and Steering Knuckle Components: ”
“Front Suspension Frame, Stabilizer Bar and/or Bushings Components: ”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Fastener Information: in Section 0A”.
1
I4RH01220007-01
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Tie-rod end lock nut 65 6.5 47.0 )
Strut bracket nut 135 13.5 98.0 ) / )
Brake hose mounting bolt 25 2.5 18.0 )
Stabilizer joint nut 60 6.0 43.5 ) / )
Front wheel speed sensor harness clamp bolt 10 1.0 7.5 )
Strut support nut 50 5.0 36.5 )
Wheel nut 100 10.0 72.5 ) / ) / ) / )
Strut nut 90 9.0 65.0 )
Wheel hub housing bolt 50 5.0 36.5 )
Caliper carrier bolt 85 8.5 61.5 )
Drive shaft nut 200 20.0 145.0 ) / )
Suspension arm ball joint nut 55 5.5 40.0 )
Front wheel speed sensor bolt 10 1.0 7.5 )
Tie-rod end nut 45 4.5 32.5 ) / )
Suspension control arm ball joint nut 55 5.5 40.0 )
Suspension control arm nut 45 4.5 32.5 )
Stabilizer bar mounting bracket bolt 50 5.0 36.5 )
Suspension frame mounting bolt 135 13.5 98.0 )
Engine front body side mounting nut 55 5.5 40.0 )
Pipe bracket bolt 11 1.1 8.0 )
Union gear box bolt 35 3.5 25.5 )
To Next Page
Loading...
Need help?
General
