Drive Shaft / Axle: Front 3A-5
5) Apply grease (including in spare parts) to inside of
tripod joint housing (1), joint it with tripod joint.
Grease color
“A”: Yellow
Amount
“A”: 127 – 137 g (4.5 – 4.8 oz) (right side)
“A”: 170 – 180 g (6.0 – 6.3 oz) (left side)
6) Fit boot to grooves of shaft and housing.
7) Insert screw driver into boot and allow air to enter
boot so that air pressure in boot becomes the same
as atmospheric pressure.
CAUTION
!
• Bend each boot band against forward
rotation.
• Do not squeeze or distort boot when
fastening it with bands. Distorted boot
caused by squeezing air may reduce its
durability.
8) Place differential side boot new big band (3) and new
small band (4) onto boot putting band outer end (1)
against forward rotation (2) as shown in figure.
9) Fasten differential side boot big band.
• For differential side boot big band
Fasten band (1) by drawing hooks (2) with special
tool and engage hooks (3) in slot and window (4).
Special tool
(A): 09943–57010
• For differential side boot small band
Fasten band (5) securely using special tool.
NOTE
Fasten boot small band securely until
complete contact “a” is obtained.
Special tool
(A): 09943–57010
I4RS0B310003-01
I5JB0A311006-01
(A)
1
4
2
3
(A)
5
“a”
I5JB0A311007-02
To Next Page
Loading...
Need help?
General
