Transfer: Non-Shift Type (Transfer without Shift Actuator) 3C-79
1. Front oil seal No.1
: Apply grease 99000-25010 to oil seal lip.
17. Differential lock clutch sleeve 33. Oil drain plug
: Apply sealant 99000-31260 to
plug thread.
2. Front case bolt 18. Front drive sprocket bush 34. Transfer to transmission bolt
3. Front case 19. Front drive sprocket 35. Front oil seal No.2
: Apply grease 99000-25010 to
oil seal lip.
4. Knock pin 20. Rear output shaft assembly 36. Rear oil seal
: Apply grease 99000-25010 to
oil seal lip.
5. Oil pipe 21. Front output shaft assembly 37. Damper
6. Input gear assembly 22. Drive chain 38. Damper bolt
7. Center case
: Apply sealant 99000-31260 to mating
surface of front case, differential lock shift
lever case and center case.
23. Rear case
: Apply sealant 99000-31260 to mating
surface of transfer rear case, oil pump
cover and transfer center case.
39. Shift case
8. Differential lock shift lever case 24. Oil level / filler plug
: Apply sealant 99000-31260 to plug
thread.
40. Shift lever case bolt
9. Needle bearing 25. Rear case bolt 41. O-ring
10. Snap ring 26. Oil strainer : 23 Nâ‹…m (2.3 kgf-m, 17.0 lb-ft)
11. Washer 27. Oil strainer bolt : 10 Nâ‹…m (1.0 kgf-m, 7.5 lb-ft)
12. Shim 28. Oil pump outer rotor : 50 Nâ‹…m (5.0 kgf-m, 36.5 lb-ft)
13. Reduction shift sleeve 29. Oil pump inner rotor : Do not reuse.
14. Center differential assembly 30. Oil pump drive pin : Apply transfer oil.
15. Front drive shaft 31. Oil pump cover
16. Thrust bearing 32. Oil pump cover bolt
To Next Page
Loading...
Need help?
General
