Suzuki GRAND VITARA User Manual

Transfer: Non-Shift Type (Transfer without Shift Actuator) 3C-85
18) Clean mating surface of both center case and rear
case (1), apply sealant to rear case as shown in
figure by such amount that its section is 1.2 mm
(0.047 in.) in diameter, mate center case with rear
case and then tighten bolts (2) to specified torque.
“A”: Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Rear case bolt (a): 23 N·m (2.3 kgf-m, 17.0 lb-ft)
19) Clean mating surface of both center case (1) and
front case, apply sealant to center case as shown in
figure by such amount that its section is 1.2 mm
(0.047 in.) in diameter, mate front case (3) with
center case and then tighten bolts (2) to specified
torque.
“A”: Sealant 99000–31260 (SUZUKI Bond
No.1217G)
Tightening torque
Rear case bolt (a): 23 N·m (2.3 kgf-m, 17.0 lb-ft)
20) Install oil strainer (1) to rear case (2).
Tightening torque
Strainer bolt (a): 10 N·m (1.0 kgf-m, 7.5 lb-ft)
21) Install oil pump inner rotor (3), outer rotor (4) and
drive pin (5) to rear case.
“A”
1
1
2, (a)
I5JB0A331101-02
“A”
1
2, (a)
2, (a)
3
I5JB0A331102-02
2
5
1
(a)
4
3
I5JB0A331103-01

Suzuki GRAND VITARA Specifications

General

Brand	Suzuki
Model	GRAND VITARA
Category	Automobile
Language	English