Automatic Transmission/Transaxle: 5A-121
14) Blow air into the second air hole from the left and
remove second brake piston. Then remove piston
inner O-ring and piston outer O-ring from second
brake piston.
15) With second brake hub assembly (3) held stationary,
turn planetary sun gear (4) clockwise to check that it
locks and then counterclockwise to check that it
turns smoothly.
16) Remove second brake hub assembly (1) from
planetary sun gear (2).
17) Remove 2 sun gear seal rings (1) from planetary sun
gear.
NOTE
Use care not to open sun gear seal ring more
than necessary.
Assembly
Assemble components by reversing disassembly
procedure and noting the following points.
• Snap both ends of sun gear seal ring (1) securely.
• Do not open sun gear seal ring more than necessary.
• Always use new O-ring and apply A/T fluid before
installation.
• When installing O-ring, make sure that it is not kinked
or caught.
• Push in brake piston horizontally.
• When installing brake piston return spring, be careful
so that spring will not fall or tilt.
• When installing snap ring, do not align lug (1) of
retainer with opening in snap ring (2).
[A]: Locks
[B]: Turns
IYSQ01510178-01
IYSQ01510179-01
IYSQ01510180-01
IYSQ01510181-01
I5JB0A510121-01
IYSQ01510182-01
To Next Page
Loading...
Need help?
General
